Why , the Map is too dark ~~~

If you are a new Irrlicht Engine user, and have a newbie-question, this is the forum for you. You may also post general programming questions here.
Post Reply
jordanXXX
Posts: 13
Joined: Sun Apr 25, 2004 4:28 am

Why , the Map is too dark ~~~

Post by jordanXXX »

I try the demos and found the q3 map is very dark ? why ???
LordNaikon
Posts: 164
Joined: Wed May 05, 2004 5:34 pm
Location: Germany Berlin
Contact:

Post by LordNaikon »

your brightness setup of your monitor iss to low or take of your sunglasses 8) then you see semething :shock: !?!
q|^.^|p beeing every time friendly to everyone
sys: 2500+Barton 512MB 6600GT WinXP
jordanXXX
Posts: 13
Joined: Sun Apr 25, 2004 4:28 am

Post by jordanXXX »

:D :D :D :D :D

I have tryed three PCs, only one is very dark ~~~ the others are a little dark :( does someone have "bright" mapes ?
etcaptor
Posts: 871
Joined: Fri Apr 09, 2004 10:32 pm
Location: Valhalla
Contact:

Post by etcaptor »

By the way
is someone knows any technique for gama changes?
LordNaikon
Posts: 164
Joined: Wed May 05, 2004 5:34 pm
Location: Germany Berlin
Contact:

Post by LordNaikon »

i am not able to give you a support of how to set up the gamma or brightness with irrlicht functions. one possibility iss to set up the brightness or gamma by your driver but I don't think that is a sufficient solution for you . I am yet not experienced enough in irrlicht to help you
q|^.^|p beeing every time friendly to everyone
sys: 2500+Barton 512MB 6600GT WinXP
Domarius
Posts: 178
Joined: Thu Mar 11, 2004 9:51 am
Location: Brisbane, QLD, Australia

Post by Domarius »

Well if you are getting different levels of brightness between different PC's, and not the same, that would suggest the problem is with the PC's and not Irrlicht, wouldn't it?

I can tell you, on my computer, the maps look fine.
Post Reply