How to identify sides of the Mesh??

ansu832001 · Post by **ansu832001** » Mon Oct 22, 2007 5:42 am

Hi All,

I want to Apply Pattern to mesh,if you look at the below picture,the right right side you can see orange colored pattern applied to it,this is done as part of initial effort.

http://allyoucanupload.webshots.com/v/2 ... 6870819687

what iam doing is iam checking normals of Mesh and assuming that the normals of one side will be same,based on that iam identifying the side of the mesh,but i think its not the right way to identify the side of the mesh.Can any body tell me how to identify sides of the mesh??

Best Regards.

JP · Post by JP » Mon Oct 22, 2007 8:12 am

Is this necessary? Are you applying the texture to the mesh at run time like in a modelling application?

Or can it be done using simple texture mapping and be pre-defined?

ansu832001 · Post by **ansu832001** » Mon Oct 22, 2007 9:01 am

Hi JP,

Yeah iam Applying Texture to the Mesh at RunTime like Modelling Application,any idea on this??

Best Regards.