X file

Steve · Post by **Steve** » Sat Jun 12, 2004 1:39 pm

I'm not sure if it is the modeler I am using exporting incorrectly or if this is the case. But I think that the xfile mesh loader is reversing all my coordinates. Does anyone else have this problem?

VPB · Post by **VPB** » Sat Jun 12, 2004 5:22 pm

Most of my models are loaded on their side

Electron_ · Post by **Electron_** » Wed Jun 16, 2004 3:42 pm

Which modeler are you using? Mine load fine.

VPB · Post by **VPB** » Wed Jun 16, 2004 4:05 pm

I personal use 3D studio max 6 with panda export

ZDimitor · Post by **ZDimitor** » Thu Jul 15, 2004 3:53 am

When I compile an example (Meshviewer) from Irrlicht v0.6 SDK, in OpenGL mode, the device incorrectly render X-model dwarf.x.

ZDimitor · Post by **ZDimitor** » Thu Jul 15, 2004 3:54 am

When I compile an example (Meshviewer) from Irrlicht v0.6 SDK, in OpenGL mode, the device incorrectly render X-model dwarf.x.

ZDimitor · Post by **ZDimitor** » Thu Jul 15, 2004 3:54 am

When I compile an example (Meshviewer) from Irrlicht v0.6 SDK, in OpenGL mode, the device incorrectly render X-model dwarf.x.

Irrlicht Engine

X file

X file

X models