If you are a new Irrlicht Engine user, and have a newbie-question, this is the forum for you. You may also post general programming questions here.
-
jordanXXX
- Posts: 13
- Joined: Sun Apr 25, 2004 4:28 am
Post
by jordanXXX »
I make a model in milk3d , and put it to IRR ,
it works , but I found the model is not too right , the left and the right is inverse~~~
am I wrong ?
-
Midnight
- Posts: 1772
- Joined: Fri Jul 02, 2004 2:37 pm
- Location: Wonderland
Post
by Midnight »
Inverse.. absolutly correct
Not sure if it's a bug but thats how it is.
if it's a problem just Mirror your final product.
-
blayde
- Posts: 45
- Joined: Fri Jul 16, 2004 12:49 pm
-
Contact:
Post
by blayde »
yeah, i found that a fiel made in milk' faced one way when saved as a .ms3d and other way when exported to .md3
could be a milkshape prob, but i assume that woulda been spotted by now.
my ver is the latest one at time of writing